At what frequency does the AM107AT sensor read and send data?
To optimize the energy consumption of the device, the AM107AT sensor can read and send data at different intervals according to the time of day.
Warning : The configuration presented below is specific to the MEQ project which can be modified according to your needs.In general, between the hours of 6h00 and 18h00 (GMT/UTC -5), the sensor sends new data to the server every 5 minutes. The data is the average of the last 5 readings measured every minute. During the night, between the hours of 18h00 (GMT/UTC -5), the sensor sends new data every hour (60 minutes).
For any other questions, do not hesitate to contact our support team for more details.
Assek Technologies' support team
1-800-833-8044
Related Articles
A sensor is transmitting partial data (missing temperature, humidity or CO2) ?
When an AM107AT reader appears to transmit partial data, where a part of the reading (temperature, humidity, or CO2) is missing, it is generally not defective. Most of the time, this is caused by inadequate coverage of the LoRaWAN network. To address ...How to set up a EM500 sensor?
Watch our installation video for more details. Here are the 4 steps to set up a EM500 sensor : 1) Remove the 4 screws under the device and remove the part with the metallic cylinder; 2) Take out the module inside. Be careful to not unplug the cable ...Which type of batteries does a AM107AT sensor use?
The AM107AT interior air quality sensor uses two AA lithium 3.6 Volt ER14505 non rechargeable batteries. For any other questions, do not hesitate to contact our support team for more details. Assek Technologies' support team support@assek.ca ...