How to set up a EM500 sensor?
Watch our installation video for more details.
Here are the 4 steps to set up a EM500 sensor :
1) Remove the 4 screws under the device and remove the part with the metallic cylinder;
2) Take out the module inside. Be careful to not unplug the cable that links the module to the reader;
3) Press for 4 seconds on the button on this module. A green light should turn on, then turn off;
4) Confirm that the EM500 sensor is working by rapidly pressing on the same button. A green light should turn on, then turn off.
For any other questions, do not hesitate to contact our support team for more details.
Assek Technologies' support team
1-800-833-8044
Related Articles
Which type of batteries does a AM107AT sensor use?
The AM107AT interior air quality sensor uses two AA lithium 3.6 Volt ER14505 non rechargeable batteries. For any other questions, do not hesitate to contact our support team for more details. Assek Technologies' support team support@assek.ca ...At what frequency does the AM107AT sensor read and send data?
To optimize the energy consumption of the device, the AM107AT sensor can read and send data at different intervals according to the time of day. Warning : The configuration presented below is specific to the MEQ project which can be modified ...A sensor is transmitting partial data (missing temperature, humidity or CO2) ?
When an AM107AT reader appears to transmit partial data, where a part of the reading (temperature, humidity, or CO2) is missing, it is generally not defective. Most of the time, this is caused by inadequate coverage of the LoRaWAN network. To address ...